Water for Injection
In stock
| Generic Brands | WFI |
|---|---|
| Manufacturer | Sun Pharma |
| Strength | 10 ml |
| PharmaceuticalForm | Injection/s |
| Delivery Time | 6 To 15 days |
Description Of Water for Injection
Water for Injection, USP is a sterile, nonpyrogenic devising of Water for Injection which include no bacteriostat, disinfectant agent or added buffer and is supplied only in single dose receptacle to dilute or dissolve drugs for injection. For IV injection, add enough amount to a solute to make an roughly isotonic solution. pH 5.0 to 7.0.
Water for Injection Chemical Name
WFI
Water for Injection Manufacturer
Sun Pharma
Uses of Water for Injection
Water for Injection is used for the nursing, control, prevention, & revision of the following illness, conditions and symptoms: Dehydration, Breathing, Sweating, Digestion
What is Water for Injection?
Water for Injection is used for creativity, Sweating, Digestion, Dehydration and other conditions. Water for Injection may also be used for purposes not listed in this medicine guide.
How Water for Injection working?
Water for injection. Water for injection is water of extra big quality without senseful contamination.Water for injection is normally made by distillation or reverse osmosis. It should contain less than a mg of component other than water per 100 ml.
How is Water for Injection used?
Your doctor or nurse will give you this pills. Kindly do not self administer.
Water for Injection Indications
Sterile Water for Injection, USP is a sterile, nonpyrogenic devising of Water for Injection which include no bacteriostat, disinfectant agent or added buffer and is supply only in single dose containers to dilute or dissolve drugs for injection
Water for Injection Dosage
Use only as a diluent or solvent. This parenteral preparation is improbable to pose a threat of fluid overload except possibly in newborn or very small baby. In the event these should occur, re-evaluate the patient and organisation appropriate remedial measures.
Contraindication Of Water for Injection
- Hypersensitivity to Water for Injection is a contraindication. In addition, Water for Injection should not be used if you have the next conditions:
- Lung tumours
- Psychiatric disorder
- Severe head injuries
Adverse effects Of Water for Injection
- headache
- increased sweating
- trouble sleeping
- unusual hair growth on your face or body
- upset stomach
- increased appetite
- nausea
- weight gain
Special Precautions And relative Warnings Of Water for Injection
Warning
Intravenous management of Sterile Water for Injection without a solute may result in hemolysis.
Where Water for Injection is essential for preparing or diluting medicine for use in newborns, only preservative-free infertile Water for Injection should be used.
Special Precautions
Do not use for intravenous injection only the osmolar close attention of additives results in an approximate isotonic admixture.
Consult the producer education for choice of vehicle, appropriate dilution or volume for dissolve the medicine to be injected, including the route and rate of injection.
Inspect reconstituted (diluted or dissolved) medicine for clarity (if soluble) and freedom from unexpected hastiness or discoloration prior to transaction.
Drug Interactions
Some medicine for injection may be incompatible in a given vehicle, or when confederate in the same vehicle. Consult with pharmacist, if available.
Storage Conditions for Water for Injection
Store at 20° to 25°C (68° to 77°F).
Protect from freezing.
Write Your Own Review